2001 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE

Rear Integration Module Programming

Prior to replacing RIM, note driver personalization features. To set or change personalization settings, see DRIVER PERSONALIZATIONΒ  .

After replacement of RIM, perform following procedure to recalibrate automatic level control:

  1. Ensure scan tool has been updated with latest software version.
  2. Connect scan tool to Data Link Connector (DLC).
  3. Turn ignition switch to RUN position.
  4. Under chassis main menu, select Rear Integration Module (RIM).
  5. Under RIM main menu, select RECALIBRATION.
  6. Follow scan tool instructions to recalibrate automatic level control.
  7. Reset personalization settings, see DRIVER PERSONALIZATIONΒ  .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.