Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmitter Programming
All transmitters which are to be recognized by Remote Control Door Lock Receiver (RCDLR) must be programmed in a single programming sequence. If system is placed in program mode, all previously programmed transmitters will be erased upon receipt of the programming signal from first transmitter. Up to four transmitters may be programmed. Do not operate or program transmitters in the vicinity of other vehicles that are in keyless entry program mode. This prevents programming of transmitters to incorrect vehicle. Order in which transmitters are programmed is important. The first transmitter programmed will be transmitter No. 1, and second transmitter programmed will be transmitter No. 2. Number on transmitters are for reference only: No. 2 can be programmed as No. 1, or vice versa. Additional unnumbered transmitters are also available. Use care to program transmitters correctly.
- Connect scan tool to Data Link Connector (DLC). DLC is located under left side of instrument panel.
- Turn ignition switch to RUN position.
- Using scan tool, select REMOTE FUNCTION ACTUATION SPECIAL FUNCTION: PROGRAM KEY FOBS to place RCLDR into PROGRAM MODE. Doors will lock and then unlock to confirm program mode.
- Press and hold lock button and unlock button simultaneously on one transmitter. After a delay of 15 seconds, doors will lock and unlock confirming programming of that transmitter.
- Repeat previous step to program up to 4 additional transmitters.
- Remove scan tool.
- Operate transmitter functions to verify correct system operation.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
