2001 Cadillac DeVille BaseFACTORY OEM SERVICE PROCEDURE

Using Scan tool

To enter programing with scan tool, perform following actions:

  1. Connect scan tool to Data Link Connector (DLC). DLC is located under left side of instrument panel.
  2. Turn ignition switch to RUN position.
  3. Select correct vehicle and model year.
  4. Select BODY.
  5. Select PERSONALIZATION.

Continue with following steps to program automatic door locks:

  1. Select SET OPTIONS.
  2. Select DRIVER #1 AUTOMATIC DOOR LOCK MODE or DRIVER #2 AUTOMATIC DOOR LOCK MODE.
  3. Highlight desired mode from following choices (see TRANSMITTER PERSONALIZATIONΒ  for mode descriptions:
    • MODE 0.
    • MODE 1.
    • MODE 2.
    • MODE 3.
    • MODE 4.
    • MODE 5.
  4. Exit menu.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.