Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Programming Security Code
Security code programming is first procedure that is required in order to program a new Theft Deterrent Module. A scan tool is used to program theft deterrent module. A new security code consists of a 4 alpha/numeric character combination that can only be programmed into theft deterrent module ONE time. Once programmed, a code combination cannot be altered or erased. For this reason, proceed with great care. A new security code is always entered twice as a cross check. When scan tool compares entered codes, if a mismatch is detected, security code input must be repeated.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
