2001 Cadillac CateraFACTORY OEM SERVICE PROCEDURE

Programming Engine Control Module Theft Deterrent Security Code

NOTE: When ECM is replaced, ECM must be synchronized with security code of theft deterrent module security code.
  1. Turn ignition off. Install scan tool. Turn ignition on, with engine off. Select SERVICE PROGRAMMING on scan tool. Program vehicle configuration as required.
  2. Follow instruction on the scan tool to request the information from the controller. Turn ignition off. Remove the scan tool from the vehicle.
  3. Connect scan tool to Techline terminal. Follow instructions on Techline terminal to perform vehicle theft deterrent learn function using SERVICE PROGRAMMING SYSTEM.
  4. Turn scan tool off. Disconnect scan tool from Techline terminal. Reconnect scan tool to vehicle. Turn ignition on, with engine off. Return to SERVICE PROGRAMMING menu and follow instructions to program frequency code.
  5. After programming is complete, clear any DTCs that may have set in ECM prior to learning correct theft determinant frequency code. Perform idle learn procedure. See IDLE LEARN PROCEDURE.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.