Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE
Preliminary Checks
- Check all related fuses located in rear fuse block. Check PWR SEAT circuit breaker (30-amp) in rear fuse block. Check DRVMDL and PASSMDL fuses (10-amp) located in rear fuse block. Ensure ground connections are clean and tight. See WIRING DIAGRAMSΒ . Check for proper installation of aftermarket electronic equipment.
- If seat motor internal circuit breaker is tripped, remove voltage from motor to reset. Check for broken or partially broken wire inside of insulation, which could cause system malfunction but prove good in a continuity/voltage check with system disconnected. These circuits may be intermittent or resistive when loaded.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
