Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Motors
Power seat uses 3 motors that control seat position. Front and back parts of seat are operated by different motors, and can be raised and lowered independently. Third motor controls forward/backward movement. If seat switch is operated to move entire seat up and down, both height motors run simultaneously. Recline motor moves angle of seatback. Headrest motor raises and lowers headrest. Lumbar support is controlled by an up/down motor (AM3), an up/down motor and in/out motor (AL2), or a pump motor and air bladder (AC9). Each power mirror uses an up/down motor and a left/right motor. Power tilt/telescoping steering wheel uses and up/down motor and an in/out motor. All motors are reversible, allowing motors to operate in each direction.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.