Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE
Continuously Variable Road Sensing Suspension Module Calibration
WARNING: This page is about a different car, the 2001 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
DTC C0563 is stored in memory of new Continuously Variable Road Sensing Suspension (CVRSS) module, and will not clear until CVRSS is calibrated. Scan tool must have latest version chassis application program to calibrate CVRSS module.
Connect scan tool to Data Link Connector (DLC). Turn ignition switch to RUN position. Follow manufacturer's instruction.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.