Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE
Rear Integration Module Programming
NOTE:
Rear Integration Module (RIM) may also be referred to as Body Control Module (BCM).
Prior to replacing RIM, note vehicle personalization features. To set or change features, perform the following procedure.
- Place shift lever in Park. Turn ignition on. Press Driver Information Center (DIC) ON button. DIC displays a status message.
- Press INFO UP button until FEATURE PROGRAMMING OFF message is displayed. Press ON button. Personalization mode is activated and FEATURE PROGRAMMING ON is displayed.
- Scroll through features using INFO DOWN button. Pressing ON/OFF button toggles through available settings. Pressing INFO DOWN button sends feature setting to appropriate system and scrolls to next feature.
- When features have been chosen, scroll to FEATURE PROGRAMMING ON display. Press INFO RESET button. Personalization mode is deactivated and FEATURE PROGRAMMING OFF message is displayed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.