2000 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE

Removal & Installation

  1. Gain access to radio and navigation data processor located under rear shelf. See RADIOΒ  . Disconnect navigation data processor and radio connectors. Remove bolts retaining navigation data processor/radio bracket to rear shelf. Remove navigation data processor, radio, and bracket assembly from the vehicle.
  2. Remove nuts retaining navigation data processor to navigation data processor/radio bracket and remove navigation data processor. To install, reverse removal procedure. Torque navigation data processor/radio bracket nuts to 80 INCH lbs. (9 N.m).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.