Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Cadillac EscaladeFACTORY OEM SERVICE PROCEDURE
Transmitter Programming
WARNING: This page is about a different car, the 1999 GMC Sierra and 1999 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Start with ignition OFF, hold down power unlock button on door panel. Turn ignition key ON, OFF, ON, OFF. Release power unlock button on door panel. The locks will cycle once.
- Hold down key FOB lock and unlock buttons for 15 seconds. The locks will again cycle once.
- Repeat step 2) for each additional key FOB.
- Turn ignition on to exit key FOB programming mode. Programming is now complete.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.