Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Cadillac EscaladeFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Body Control Module (BCM) | In Center Console |
| Data Link Connector (DLC) | Under Left Side Of Instrument Panel, Near Steering Column |
| Electronic Brake Control Module (EBCM) | Near Brake Master Cylinder |
| Electronic Variable Orifice (EVO)/Passlock Control Module | Under Center Of Instrument Panel |
| Instrument Panel Fuse Block | Behind Left End Of Instrument Panel |
| Powertrain Control Module (PCM) | Behind Glove Box, Under Right Side Of Instrument Panel |
| Remote Control Door Lock Receiver | On Steering Column Support Bracket |
| Transfer Case Control Module (TCCM) | Behind Left Side Of Instrument Panel, On Steering Column Support Bracket |
| Underhood Fuse Block | Left Rear Corner Of Engine Compartment |
| Vehicle Control Module (VCM) | Left Side Of Engine Compartment, On Fenderwell |
| Vehicle Interface Unit (VIU) | Under Right Rear Seat |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
