Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal & Installation
Turn ignition off. Electronic Brake Control Module (EBCM) is located under air cleaner assembly, attached to subframe. See Figure . Remove air cleaner assembly and reposition Powertrain Control Module (PCM) to gain access to EBCM. Raise and support vehicle. Remove lower radiator and left front wheel well splash shield. Remove 3 EBCM bracket nuts. Remove 2 lower EBCM to Brake Pressure Modulator Valve (BPMV) bolts. Lower vehicle and disconnect EBCM connector. Remove front insulator and insulator mounting bolt. Remove 2 upper EBCM to BPMV bolts. Do not pry EBCM from BPMV. Separate EBCM from BPMV using care not to damage seal. See Fig 1 . To install, reverse removal procedure.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
