Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Cadillac CateraFACTORY OEM SERVICE PROCEDURE
Test 4: Right Front Window Express Feature Inoperative
- If power window system check was performed, go to next step. If power window system check was not performed, perform system check. See SYSTEM CHECK under TROUBLE SHOOTING.
- If right front window regulator motor operates properly from right front window switch, go to step 4 . If right front window regulator motor does not operate properly from right front window switch, go to next step.
- Go to TEST 7: RIGHT FRONT WINDOW INOPERATIVE . After repair is complete, go to step 7 .
- Program right front window regulator motor. See WINDOW MOTOR under PROGRAMMING. When programming is complete, go to next step.
- If right front window regulator motor express up and down operates properly, system is okay. If right front window regulator motor express up and down does not operate properly, go to next step.
- Replace right front window regulator motor. See WINDOW REGULATOR & MOTOR under REMOVAL & INSTALLATION. After repair is complete, go to next step.
- Connect all connectors and components that were disconnected. Verify right front window express up and down feature operates properly. If right front window express up and down feature does not operate properly, go to step 1 .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
