SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC1997SEVILLE SLSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSANTI-THEFT SYSTEMPROGRAMMINGREAR INTEGRATION MODULE (RIM) PROGRAMMING
1997 Cadillac Seville SLS

Rear Integration Module (Rim) Programming

1997 Cadillac Seville SLSSECTION Rear Integration Module (Rim) Programming
NOTE: RIM may be referred to as BCM.

Prior to replacing RIM, note vehicle personalization features. To set or change features:

  1. Place gear selector in PARK. Turn ignition on. Press Driver Information Center (DIC) ON button. DIC displays a status message.
  2. Press INFO UP button until FEATURE PROGRAMMING OFF message is displayed. Press ON button. Personalization mode is activated and FEATURE PROGRAMMING ON is displayed.
  3. Scroll through features using INFO DOWN button. Pressing ON/OFF button toggles through available settings. Pressing INFO DOWN button sends feature setting to appropriate system and scrolls to next feature.
  4. When features have been chosen, scroll to FEATURE PROGRAMMING ON display. Press INFO RESET button. Personalization mode is deactivated and FEATURE PROGRAMMING OFF message is displayed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.