Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Cadillac CateraFACTORY OEM SERVICE PROCEDURE
Left Front Window Inoperative From Left Front Switch
- If power window system check was performed, go to next step. If power window system check was not performed, see POWER WINDOW SYSTEM CHECKΒ .
- Disconnect left front side door window regulator motor connector. Using DVOM connected to ground, measure voltage at left front side door regulator motor 6-pin connector terminal No. 1 (Red wire). If battery voltage exists, go to step 4). If battery voltage does not exist, go to next step.
- Repair open or high resistance in Red wire between left front side door window regulator motor and splice S271. After repair is complete, go to step 11).
- Using DVOM connected to ground, measure resistance of Black wire at left front side door window regulator motor connector terminal No. 4. If resistance is less than 5 ohms, go to step 6). If resistance is not less than 5 ohms, go to next step.
- Repair open or high resistance in Black wire between left front side door window regulator motor and splice S503.
- Turn ignition switch to RUN position. Press left front side door window switch UP button. Using DVOM connected to ground, measure voltage at left front side door window regulator motor connector terminal No. 2 (Gray/Green wire). If battery voltage exists, go to step 8). If battery voltage does not exist, go to next step.
- Repair open or high resistance in Gray/Green wire between left front side door window switch and left front side door window regulator motor. If Gray/Green wire okay, replace left front side door window switch. After repair, go to step 11).
- Press left front side door window switch DOWN button. Using DVOM connected to ground, measure voltage at left front side door window regulator motor connector terminal No. 3 (Blue/Red wire). If battery voltage exists, go to step 10). If battery voltage does not exist, go to next step.
- Repair open or high resistance in Blue/Red wire between left front side door window switch and left front side door window regulator motor. After repair, go to step 11).
- Replace left front side door window regulator motor. After repair, go to next step.
- Connect all connectors and components that were disconnected. Verify left front side door power window operates properly. If left front side door power window does not operate properly, go to step 1).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
