1996 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application Preferred Range
Camber (1)
Front (2)
Left 0 -.5 To .5
Right 0 -.5 To .5
Cross Camber 0 -.75 To .75
Rear 0 -0.5 To 0.5
Caster (1) 2.5 1.5 To 3.5
Toe-In (1)
Front 0.2 0 To 0.4
Rear 0.2 0 To 0.4
Toe-In (3)
Front 0.1 (2.5) 0 To 0.2 (0 To 5.0)
Rear 0.1 (2.5) 0 To 0.2 (0 To 5.0)
(1) Measurement is in degrees.
(2) This is a revised specification. See GM TSB 53-31-03, issued December 1995. See TECHNICAL SERVICE BULLETIN .
(3) Measurement is in inches (mm).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.