Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Cadillac Eldorado BaseFACTORY OEM SERVICE PROCEDURE
Body Control Module (BCM): Installation
WARNING: This page is about a different car, the 1996 Cadillac Seville and 1996 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
- Install BCM and reconnect harness connectors. Install rear seat back and cushion. Install 10-amp COMFORT fuse in trunk compartment fuse block. Reconnect negative battery cable.
- Reprogram PZM override PZ S33 according to following values.
- K = Seville = 4
- Ksp = DeVille/Concours = 5
- Press and hold DEFROST and AUTO buttons on CCP until display flashes. Cycle ignition. Clear DTCs.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.