Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Cadillac Eldorado BaseFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| EGR Pipe Bolt | 21 (28) | |
| Oxygen Sensor | 30 (41) | |
| INCH Lbs. (N.m)Β | ||
| Intake Manifold Cover Nuts | 18 (2.0) | |
| Throttle Body Bolts | 106 (12) | |
| Throttle Position Sensor Screw | 20 (2.3) | |
| Ignition System | ||
| Camshaft Position Sensor Bolt | 89 (10) | |
| Crankshaft Position Sensor Bolt/Nut | 89 (10) | |
| Ignition Coil-To-Module Screws | 30 (3.4) | |
| Ignition Control Module/Coil Pack Mounting Bolts | 106 (12) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
