Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Cadillac AllanteFACTORY OEM SERVICE PROCEDURE
Quick Lookups: Fluids
| FLUID CAPACITIES | |||||||
|---|---|---|---|---|---|---|---|
| Fluid Type | Application | Standard | Metric | Fluid Spec | Note | S/H | |
| Air Cond Refrigerant | 2.88 LBS. | 1.3 KG | R-12 | S | |||
| Automatic Transmission Fluid | 15.00 QTS. | 14.19 L | Automatic Transmission Fluid DEXRON IIE | S | |||
| Brake Fluid | N/A | N/A | DOT 3 Brake Fluid | S | |||
| Differential Gear Oil | N/A | N/A | GM Gear Oil | S | |||
| Engine Coolant | 12.30 QTS. | 11.64 L | 50/50 mixture of Ethylene Glycol Base Coolant and water | GM Specification 1825-M. | S | ||
| Engine Oil | w/Filter | 7.00 QTS. | 6.62 L | API - SAE 5W-30 (Below -20Deg.F to 60Deg.F), 10W-30 (Preferred) (0Deg.F to Above 100Deg.F), 30 (40Deg.F to Above 100Deg.F) | S | ||
| Engine Oil | w/o Filter | 6.50 QTS. | 6.15 L | API - SAE 5W-30 (Below -20Deg.F to 60Deg.F), 10W-30 (Preferred) (0Deg.F to Above 100Deg.F), 30 (40Deg.F to Above 100Deg.F) | S | ||
| Fuel Tank | 22.50 GALS. | 85.17 L | S | ||||
| Power Steering Fluid | 1.30 QTS. | 1.23 L | GM Power Steering Fluid | S | |||
| Windshield Washer Fluid | 1.20 GALS. | 4.54 L | Optikleen Windshield Washer Fluid | Follow the Manufacturer's Instructions for the mixture ratio. | S | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.