Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pcm Code E098, Park/Neutral-To-Drive/Reverse While In ISC Control Range: Description
This test monitors idle speed and gear selection from Park or Neutral to Drive or Reverse when throttle is in ISC speed range. If idle speed is greater than desired, PCM will retard spark advance and set code.
PCM Code E098 could be driver-induced by shifting into gear with throttle angle of less than 20 degrees with throttle depressed.
Check for PCM Code E030 as a slow or inoperative ISC motor may cause Code E098 to set.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
