Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pcm Code E031, Shorted Map Sensor Circuit: Action
PCM turns on SERVICE ENGINE SOON light, sets BARO equal to 92 kPa and uses a substitute MAP sensor value based on engine RPM and throttle switch status (open or closed).
- If PCM parameter ED02 goes to 14-16 kPa with sensor unplugged, fault is at MAP sensor or sensor connector.
- This checks for an open circuit from terminal "A" of sensor connector to PCM terminal A5 (ground). If ground is open, sensor cannot divide reference voltage to make signal voltage vary. Signal voltage is always high.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.