Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Cadillac Seville BaseFACTORY OEM SERVICE PROCEDURE
Pcm Code E023, Est Circuit Problem: Action
PCM turns on SERVICE ENGINE SOON light and will not enable spark timing control. Engine will start and run on base timing.
NOTE:
Test numbers refer to numbers on diagnostic chart.
- When circuit No. 423 is shorted to ground, engine will have a long crank and hard start condition. When PCM detects grounded circuit, by-pass line will be shifted low.
- With only distributor reference (distributor reference ground jumpered), engine will run on back-up spark control. This checks for proper ground connections between PCM and engine and between PCM and HEI.
- This ensures PCM provides EST output signal over circuit No. 423.
- This checks if HEI module can ground EST signal with an open by-pass circuit.NOTE: Test numbers refer to numbers on diagnostic chart.
- This checks if HEI module can recognize a voltage on by-pass circuit and stop grounding EST (PCM-controlled timing).
- This checks for by-pass signal to module. If by-pass signal is being sent by PCM to HEI and if module is interpreting by-pass voltage correctly, module will switch off ground to EST.
- Fault may exist in 6-way connector. Check connector and terminals for damage. If connector is okay, plug in connector, and retest for PCM Code E023.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
