Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pcm Code E014, Shorted Coolant Sensor Circuit: Description
Coolant sensor is a 2-wire sensor with signal voltage coming from PCM to sensor terminal "B" (circuit No. 410) and a sensor reference ground on terminal "A" (circuit No. 1076).
As sensor temperature increases, resistance decreases. Signal voltage from PCM to terminal "B" decreases as sensor temperature increases and current flows through sensor element to terminal "A" (sensor ground). PCM Code E014 sets because PCM assumes coolant temperature cannot be 298°F (148°C) or greater when MAT is 212°F (100°C) or less.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
