Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Cadillac Seville BaseFACTORY OEM SERVICE PROCEDURE
Antenna/Transmitter Operation Test
- Disconnect antenna from keyless entry module. Hold a transmitter close to keyless entry module and push unlock button. If left door unlocks, go to step 2). If left door does not unlock, reprogram keyless entry module and repeat step. If left door still does not unlock, go to POWER & GROUND TESTΒ . If left door does unlock, reprogram keyless entry module using other transmitter.
- Check antenna connections at keyless entry module and at rear window for good contact. Check continuity of antenna grid by measuring resistance. Place one meter probe at one end of grid and other probe on connector terminal. If meter reads an open circuit, there is a break in the grid.
- Location of break can be found by moving outer probe toward connector, keeping probe in contact with grid. Break is located at point where resistance drops. If antenna grid is okay, problem is in coaxial cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
