Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Control Module
The CCR control module is a computer used exclusively to control and monitor the CCR system. It is located on a bracket under the package shelf in the trunk. The control module receives speed, lift/dive and acceleration switch input and determines the optimum mode strut valving for current operating conditions. the control module also receives feedback from the struts to determine proper system operation. If the control module receives an incorrect feedback signal an error code will be set in CCR memory and a "SERVICE RIDE CONTROL" message will be displayed on the Driver Information Center. For diagnostic purposes, Grounding the Diagnostic Enable circuit will cause a Light Emitting Diode (LED) on the control module to flash codes.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
