1992 Cadillac Seville BaseFACTORY OEM SERVICE PROCEDURE

PASS-Key System Verification

  1. Ensure system will detect the use of an incorrect key by turning off engine. Disconnect PASS-Key connector at base of steering column. Connect Interrogator (J-35628) to connector. Set key code on interrogator to an incorrect key code. Attempt to start engine.
  2. If engine cranks, replace PASS-Key decoder module and repeat PASS-KEY DIAGNOSTIC SYSTEM CHECK. If engine does not crank within 3 minute lockout period while SECURITY indicator is on, disconnect interrogator and reconnect connector at base of steering column. Attempt to start engine. If engine cranks, replace decoder module and repeat PASS-KEY DIAGNOSTIC SYSTEM CHECK.
  3. If engine does not crank, turn ignition switch to OFF position. Wait at least 3 minutes (until SECURITY light goes off) to end of lock-out period and attempt to start vehicle. If engine does not start, see NOTES ON INTERMITTENTSΒ  . If engine does start, system is functioning correctly. If an intermittent problem is suspected, see NOTES ON INTERMITTENTS.
Pass Key Resistance Values

Key Resistance Number Ohms Value
1 402
2 523
3 681
4 887
5 1130
6 1407
7 1870
8 2370
9 3010
10 3740
11 4750
12 6040
13 7500
14 9530
15 11800
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.