1992 Cadillac Seville BaseFACTORY OEM SERVICE PROCEDURE

PASS-Key Diagnostic System Check

  1. Check for diagnostic codes. See appropriate G - TEST W/CODES article in the ENGINE PERFORMANCE Section. Check SECURITY light while attempting to start vehicle.
  2. If engine cranks but does not start, see ENGINE CRANKS BUT DOES NOT START. If engine does not crank or start, check SECURITY light function. If light flashed or stayed on at all times, see SECURITY LIGHT EITHER FLASHES OR STAYS ON ALL THE TIME. If light never came on, see SECURITY LIGHT DOES NOT COME ON. If light came on, then went off after approximately 5 seconds, see ENGINE DOES NOT CRANK OR START & SECURITY INDICATOR LIGHT COMES ON & WENT OFF AFTER ABOUT 5 SECONDS.
  3. If engine cranks and starts, and SECURITY light came on and went off after about 5 seconds, system operates normally. See NOTES ON INTERMITTENTSΒ  . If light never came on, see SECURITY LIGHT DOES NOT COME ON. If light comes on at all times, see ENGINE CRANKS & STARTS, SECURITY INDICATOR STAYS ON. If light flashes on and off, see SECURITY LIGHT EITHER FLASHES OR STAYS ON ALL THE TIME.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.