Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Cadillac Eldorado BaseFACTORY OEM SERVICE PROCEDURE
Pcm Code E071, Intermittent Map Sensor: Action
PCM Code E071 set. No service message is given.
NOTE:
Test number refers to number on diagnostic chart.
- Check terminal crimp to wire, and ensure terminals are properly seated in connectors. 5-volt reference can be tested by jumpering harness terminals "A", "B" and "C" to MAP sensor terminals "A", "B" and "C". Connect DVOM positive lead to jumper lead "C" and negative lead to jumper lead "A". Turn ignition on. Apply vacuum signal to sensor and tap lightly on sensor using a pencil or pocket screwdriver. Voltage should remain 4.6-5.1 volts when sensor is tapped.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.