Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
BCM Code B552, Keep Alive Memory Error
Code B552 does not indicate a fault but is a normal occurrence anytime power to BCM has been interrupted. Code cannot be cleared from memory in normal manner. Code can only be cleared if it is not current. Under normal conditions, code will become history when ignition key is turned to LOCK position, wait 5 seconds and turn key to ON position. Then, re-enter diagnostics. This code should now be history, and can be cleared in normal manner.
This code will also set if following conditions are met: ignition is cranked; and/or, no system voltage signal to BCM terminal 1C9. The purpose of crank circuit is to signal BCM to shut off when cranking so normal voltage variations during starting do not affect electronic devices.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
