Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
BCM Code B113, In-Car Temperature Sensor Circuit: Notes
The in-car air temperature sensor is a thermistor that controls signal voltage to BCM. The BCM supplies and monitors voltage on circuit No. 734 to sensor. When sensor is cold, its resistance is high; therefore, BCM will see a high signal voltage. As sensor warms, its resistance becomes less and signal voltage is pulled low through sensor ground, circuit No. 736. This signal voltage will vary between 5 volts (open circuit) and zero volts (shorted circuit).
Code B113 will set if ignition is on, outside temperature sensor is working properly, ambient temperature is greater than -18°C and signal voltage indicates less than -34°C (open circuit) or more than 96°C (shorted circuit). During a failure, a substitute temperature reading is used to allow continued operation of A/C-heater system and in-car temperature reading BD25 will display actual sensor reading.
- BCM parameter BD25 displays in-car temperature. The normal range is -34°C to 96°C.
- Check to see if open circuit is caused by circuit or sensor. If open circuit reading changes to shorted circuit reading after disconnecting sensor, BCM and wiring are okay.
- By applying ground to various points in circuits, an open can be isolated by observing whether parameter display can be changed from open reading to shorted reading.
- Check to see if shorted circuit reading is caused by circuit or sensor. If short circuit reading changes to an open circuit reading after disconnecting sensor, BCM and wiring are okay.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
