Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Cadillac Seville BaseFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | Location | ||
|---|---|---|---|
| Express Down Window Module | In center rear of LH front door, in front of door lock motor. See Fig 1 | ||
| Fuse Block | Behind RH side of I/P, in glove box. See Fig 2 | ||
| Interior Relay Center (1) | Behind RH side of Instrument panel, below glove box. See Fig 3 | ||
| Window Motors | In center front of respective doors. See Fig 4 | ||
| C200 (56 Cavities) | Behind right side Of instrument panel near nhroud. See Fig 3 | ||
| C308 (6 Cavities) | Near base of left hand center pillar. See Fig 5 | ||
| C309 (6 Cavities) | Near base of right hand center pillar. See Fig 5 | ||
| C310 (6 Cavities) | Near base of left hand center pillar. See Fig 5 | ||
| C311 (6 Cavities) | Near base of right hand center pillar. See Fig 5 | ||
| G301 | Behind left side of instrument panel near shroud.See Fig 6 | ||
| P500 | In front of left front door, near shroud. See Fig 1 | ||
| P600 | In front of right front door, near shroud. See Fig 1 | ||
| P700 | Left hand center pillar, in front of left rear door. See Fig 5 | ||
| P800 | Right hand center pillar, in front of right rear door. See Fig 5 | ||
| S205 | Dash harness, behind RH side of instrument Panel in end of dash harness channel See Fig 3 | ||
| S317 | Body main harness, front of LH front door sill. See Fig 6 | ||
| S398 | Body main harness, below RH front seat, at RH end of conduit. See Fig 7 | ||
| S526 | Body main harness, in LH front door, ten inches from power window switch. See Fig 1 | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
