1989 Cadillac Seville BaseFACTORY OEM SERVICE PROCEDURE

ECM "SNAPSHOT?" Selection

Selection of "SNAPSHOT?" test type while in the ECM system level will allow the recall of up to 3 snapshots recorded at the time the ECM malfunction codes were set. See Figure . Also, one may trigger the recording of a snapshot upon demand. Pressing the "HI" button while in the ECM system level, will result in the display of "EXXX SNAPSHOT?". The "XXX" is the 3-digit diagnostic code that recorded the snapshot. While selecting snapshot, any of the following actions may be taken to control the display:

  • Pressing "OFF" button on CCDIC panel will stop the test type selection process and return the display to the next available system selection.
  • Pressing the "LO" button will allow scrolling through the list of ECM diagnostic codes that the ECM has stored a snapshot for. Pressing the "LO" button will display the "TAKE ECM SNAPSHOT?" message and return system to the first "EXXX SNAPSHOT?" display.
  • Pressing the "HI" button with "SNAP DATA?" or "SNAP INPUTS?" displayed, will select that test type. At this point the display is controlled as it would be for non-snapshot data and input displays; however, all values and status information represents memorized vehicle conditions.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.