Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Input Code EI80 - Cruise Control Set/Coast Input: Notes
The cruise control "SET/COAST" switch is normally open and provides a 12-volt signal to ECM terminal B4 when switch is depressed. When cruise control dash switch is depressed to "ON" position, the dash switch provides a 12-volt signal to the cruise control/steering column switch on terminal A4 of circuit No. 397. When "SET/COAST" button is depressed, the steering column switch terminal A4 is connected to terminal E3 of circuit No. 84, providing the ECM with a 12-volt input on terminal B4.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
