Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Cadillac Seville BaseFACTORY OEM SERVICE PROCEDURE
Code B420 - Courtesy Light Relay Circuit: Notes
If courtesy lights did not cycle on and off when BO04 was selected, then courtesy lights relay set code B420.
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- Checks if fault is caused by an open circuit or a short to ground. If courtesy lights are always on, then there is a short to ground in control circuit. If courtesy lights are never on, then there is an open in one of the circuits.
- Checks if short to ground is due to circuit or BCM.
- Checks if open circuit is due to circuit or BCM.
- Checks if open circuit is on power side of relay.
- Checks is open circuit is on ground side of relay or if relay is at fault.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
