Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code B337 - Loss Of A/C-Heater Programmer Data: Notes
If BCM has lost data communication with A/C-heater programmer and ignition is on, code B337 will set. Fault can be caused by a loss of 12 volts power, ground to programmer or a double open in programmer data line, one on each side of component. During a failure, A/C clutch is disabled and blower motor runs at a constant 6 volts.
- Ensures code is not intermittent.
- Determines if fault is due to power or ground circuits or data line.
- Determines if data line fault is due to wiring or programmer.
- Checks for "IGN. 3" to programmer.
- Determines if loss of ground is due to programmer, wiring or CPS.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.