Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
ECM Input Code EI81 - Cruise Control Resume/ACCEL Input: Notes
The ECM cruise control "RESUME/ACCEL" switch is normally open and provides a 12-volt signal to ECM over pin "B6" when depressed. When cruise control dash switch is depressed to "ON" position, the dash switch provides a 12-volt signal to the cruise control/steering column switch over pin "A4" of circuit No. 397. When "RESUME/ACCEL" button is depressed, the steering column switch pin "A4" is connected to pin "C" of circuit No. 87, providing the ECM with a 12 volt resume/accel input on terminal "B6".
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.