1988 Cadillac Cimarron AutomaticFACTORY OEM SERVICE PROCEDURE

Idle Air Control

The Idle Air Control (IAC) valve controls engine idle speed during engine load changes to prevent stalling. Mounted in the throttle body, the IAC controls by-pass air around throttle valve. Movement of IAC conical valve inward toward the seat decreases airflow while movement away from the seat increases airflow around throttle plate.

The IAC valve moves in small steps called "COUNTS", and can be measured with test equipment plugged into the Assembly Line Diagnostic Link (ALDL). Increase of "COUNTS" indicates more air passing IAC valve.

Proper positioning of IAC valve at idle is determined by the ECM based on battery voltage, coolant temperature, engine load and engine RPM. Drop in engine speed below a specified RPM, with throttle plate closed, the ECM senses a near stall condition. The ECM then repositions IAC valve to prevent stalls.

Disconnecting and reconnecting of IAC valve with engine running will result in incorrect idle RPM. The IAC valve must be reset. On 2.0L, the IAC is reset when vehicle is operated over 35 MPH. On all others, IAC resets when ignition switch is turned from the "ON" to the "OFF" position. When servicing IAC, disconnect or connect only with ignition off to prevent resetting of IAC.

The IAC valve affects only the idle system. If valve is stuck fully open, excessive airflow into the manifold creates an high idle speed. Valves stuck closed allows insufficient airflow, resulting in low idle speed. Different design IAC valves are used. Ensure proper design valve is used during replacement.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.