Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Cadillac SevilleFACTORY OEM SERVICE PROCEDURE
Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Preferred | Range |
|---|---|---|
| Camber (Degrees) Front | 0 | -13/16 to 13/16 |
| Camber (Degrees) Rear | -3/32 | -13/32 to 7/32 |
| Caster (Degrees) Front | 2 5/16 | 1 5/16 to 3 5/16 |
| Caster (Degrees) Rear | N/A | N/A |
| Toe-In (Inches) Front | 0 | -3/32 to 3/32 |
| Toe-In (Inches) Rear | 3/32 | 0 to 3/16 |
| Toe-In (Millimeters) Front | 0 | -2.5 to 2.5 |
| Toe-In (Millimeters) Rear | 3/32 | 0 to 5 |
| Toe-In (Degrees) Front | 0 | 0.22 to 0.38 |
| Toe-In (Degrees) Rear | 3/16 | 0 to 3/8 |
| Wheelbase (Inches) | 103.4 | N/A |
| Wheelbase (Millimeters) | 2743 | N/A |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.