Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Cadillac SevilleFACTORY OEM SERVICE PROCEDURE
DFI Components Removal & Installation (4.1L): Precautions
CAUTION:
When certain materials rub together, a transfer of electrons from one material to another may occur under special conditions. This results in an electrostatic charge (static electricity) being built up in one of the materials. When any conducting material comes in contact with the charged material, electrostatic discharge occurs, transferring electrons to the third material. Since electronic components used in control systems are designed to carry very low voltages, as little as a 30-volt charge created by static electricity can cause a total or degrading failure in ECM or other electronic components containing integrated circuits. Before servicing ECM, ground yourself and ground the work area to discharge stored electricity.
STATIC CHARGE (VOLTS)
| Movement Causing Charge | % Relative Humidity 10-20 | % Relative Humidity 65-90 |
|---|---|---|
| Walking Across Carpet | 35,000 | 1500 |
| Handling Clear Plastic Bag | 20,000 | 1200 |
| Sliding Across Velour Seat | 15,000 | 400 |
| Walking Across Tile/Vinyl | 12,000 | 50 |
| Handling Vinyl Envelope | 7000 | 600 |
CAUTION:
DO NOT
remove part from packaging until ready to install. Ground any static proof package PRIOR to opening. DO NOT
touch electrical terminals of components unless properly grounded. DO NOT
lay electrical components on car seat, carpeting or dashboard. Use electrostatic protection mat and ground strap whenever possible. See Fig 1
.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
