1987 Cadillac Cimarron AutomaticFACTORY OEM SERVICE PROCEDURE

Fuel Rails

The extruded fuel rail assembly includes a fuel pressure regulator, individual high pressure fuel injectors and cold start injector. The injectors fit into individual sockets in the base plate. The fuel rails used on 2.0L, 3.0L and 3.8L engines are manufactured, assembled and flow tested with the injectors as an assembly.

Fig 1: Typical In-Tank Roller Vane Fuel Pump
G3251Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.