1987 Cadillac Cimarron AutomaticFACTORY OEM SERVICE PROCEDURE

Code 33 - Map Sensor Signal High: Notes

NOTE: For additional Code 33 information, refer to TSB MANUAL UPDATE-SEC. 6E1/6E2/6E3 CODE 33,34,63,64 (NON-TURBOS) .

The Manifold Absolute Pressure (MAP) sensor responds to changes in manifold pressure (vacuum). The ECM receives this information as a voltage signal which will vary from about 1-1.5 volts at idle (high vacuum/low pressure) to about 4-4.5 volts at wide open throttle (low vacuum/high pressure).

NOTE: Test numbers refer to test numbers on diagnostic chart.
  1. Code 33 will set if the following conditions are met:
    • Engine running.
    • Manifold pressure is greater than specified.
    • Throttle angle is less than 2 percent.
    • All conditions have been met for 4-5 seconds. Engine misfire, or a low unstable idle may set a Code 33.
  2. With the MAP sensor disconnected, the ECM and "Scan" tester should recognize a low voltage. If low voltage is shown on tester, ECM and harness are not at fault.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.