Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Cadillac Seville V6-252 4.1LFACTORY OEM SERVICE PROCEDURE
Engine Control Module: Service and Repair
1. Disconnect battery ground cable.
2. Disconnect two ECM electrical connectors.
3. Remove the ECM mounting hardware.
4. Remove ECM from passenger compartment.
5. Reverse procedure to install.
CAUTION: Replacement ECM is supplied without engine calibration unit (PROM) and care must be taken when removing the PROM from a defective ECM as it will be used in the replacement ECM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.