Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Cadillac Cimarron Automatic TransFACTORY OEM SERVICE PROCEDURE
Height Sensor Operational Test
- Cycle system with ignition switch.
- Raise vehicle on hoist and support axle housing at riding height.
- Check all wiring for good connections.
- Disconnect link from height sensor arm. See Fig 1.
- Move metal sensor arm "UP".
- There should be a delay of 8-14 seconds before compressor turns "ON" and shock absorbers start to inflate.
- As soon as shock absorbers fill, stop compressor by moving metal sensor arm "DOWN".
- Move sensor arm below position where compressor stopped running.
- There should be a delay of 8-14 seconds before shock absorbers start to deflate and vehicle lowers.
- If height sensor does not function properly, replace it with correct model.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.