Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Cadillac Cimarron Automatic TransFACTORY OEM SERVICE PROCEDURE
Wipers Completely Inoperative
- Turn ignition switch to "ON" position and wiper switch to "HIGH". Ground a 12 volt test lamp and touch probe to wiper terminal 1. If lamp lights, proceed to next step. If lamp does not light, check for a blown fuse. If fuse is okay, repair open in feed circuit between fuse block and wiper motor. If fuse is blown, replace fuse and check for short in wire or for high amperage draw of wiper motor.
- With wiper switch in "LOW", connect a jumper wire from ground to wiper motor housing. If wipers run, repair open in ground strap. If wipers do not run, problem is in internal mechanisms of wiper motor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
