1982 Cadillac Cimarron Automatic TransFACTORY OEM SERVICE PROCEDURE

Components & Functions: Programmer

The plastic programmer case contains temperature control components and is mounted on the right hand end of the heater-A/C assembly. The circuit board is an amplifier and logic board which accepts electrical signals from the sensors and mode pushbuttons in the control head and provides output control signals. A reversible D.C. motor actuates a rotary shaft which drives the air-mix door link. Signals from the circuit board actuate the vacuum solenoids within the programmer which control the water valve, air door, mode door and defroster door.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.