Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2019ENVISION BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUPREPAIR INSTRUCTIONSK71 TRANSMISSION CONTROL MODULE: PROGRAMMING AND SETUP (9T60 (M3T))REPLACE AND PROGRAM CONTROL MODULE
2019 Buick Envision Base
Replace and Program Control Module
2019 Buick Envision BaseSECTION Replace and Program Control Module
To program a replacement K71 Transmission Control Module (TCM), perform the following procedure:
- Replace the K71 Transmission Control Module.
- Install EL-49642 SPS programming support tool
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- Perform one of the following SPS Programming functions:
- K20/ K71 Engine and Transmission Control Modules and follow the on-screen instructions
- K71 Transmission Control Module and follow on-screen instructions.
NOTE:If both controller options below are listed, select K71 Transmission Control Module
- Perform the Refresh Characterization Data at the MCVM Characterization procedure, follow the on-screen instructions.
- Perform the Vehicle Setup, follow the on screen instructions.
- With a scan tool, clear DTCs from the K71 Transmission Control Module.
- Ignition OFF for 2 minutes.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.