2019 Buick Encore BaseFACTORY OEM SERVICE PROCEDURE

Fastener Specifications

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal.Β 

Application Specification
Metric (English)
Inside Rearview Mirror Screw 2 N.m (18 lb in)
Outside Rearview Mirror Gasket Fastener 3 N.m (27 lb in)
Outside Rearview Mirror Housing Cover Bezel Screws 1.5 N.m (13 lb in)
Outside Rearview Mirror Housing Upper Cover Bolt 1.5 N.m (13 lb in)
Outside Rearview Mirror Inner Actuator Screw 5 N.m (44 lb in)
Outside Rearview Mirror Nut 9 N.m (80 lb in)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.