Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2019 Buick Cascada BaseSECTION Installation Procedure
Install the current sensor (2) to the battery negative cable (1).
Install the current sensor (5) to the battery tray.
- Connect the wiring harness current sensor plug (4).
Install the battery negative cable (2).
- Install the battery ground cable nut (1) and tighten to 9 N.m (80 lb in).
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
- Close the hood.
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.