SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2018REGAL BASEREPAIR AND DIAGNOSISGENERAL INFORMATIONRESET PROCEDURESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK47 REAR DIFFERENTIAL CLUTCH CONTROL MODULE: PROGRAMMING AND SETUPREPLACE AND PROGRAM CONTROL MODULE USING EXISTING REAR DIFFERENTIAL ASSEMBLY
2018 Buick Regal Base

Replace and Program Control Module Using Existing Rear Differential Assembly

2018 Buick Regal BaseSECTION Replace and Program Control Module Using Existing Rear Differential Assembly

To program a replacement control module, perform the following procedure:

    NOTE:

    Steps 1-3 must be performed BEFORE the old K47 Rear Differential Clutch Control Module is removed from the vehicle.

  1. Install EL-49642  SPS Programming Support Tool.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select K47 Rear Differential Clutch Control Module - Prepare the Control Module for Removal and follow the on-screen instructions.
  4. Replace the K47 Rear Differential Clutch Control Module.
  5. On the SPS Supported Controllers screen, select K47 Rear Differential Clutch Control Module - Programming and follow the on-screen instructions.
  6. On the SPS Supported Controllers screen, select K47 Rear Differential Clutch Control Module - Setup and follow the on-screen instructions.
    NOTE:

    RPO G99 = Twin Clutch System

  7. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.